Do-it-yourself kits are available from many awning companies. It should be easy if you follow the tips and follow the instructions in your kit.
Start by placing the gutter on a few sawhorses. Use a tape measure to mark each foot of the gutter. The same process is done with the hanger.
These marks can be used later to ensure that the panels are square. If you are looking for the best awnings and patios, then you can get at azsunsolutions.com that will provide the best protection from the harsh Arizona heat, harmful UV Rays, light winds, and insects.
Next, install the hanger in your home with 1 1/2" hex-head screws. Run a thin layer of silicone on the hanger's top, near the home. This will be covered with flashing and sealed again later.
Next, prepare the gutter. Begin by measuring 18 inches from the gutter's ends. Then, mark your brackets. To evenly space your other brackets, you will need to do some math.
Each bracket should be attached to the gutter using one self-tapping screw located near the corner. This allows you to drill holes for the nuts and bolts.
It is a good idea to trim the posts before attaching them to the brackets. Again, this step requires some math. Place the gutter in the most convenient place. Take a measurement from your home and measure it squarely.
This will allow you to get as precise as possible at this point. Use your level and some wooden blocks as shims to level the gutter on the sawhorses. Most times, one end of your gutter will be closer than the other.